Installation features and standards of ferrule joint

Structure of ferrule type pipe joint: ferrule, joint body and nut. The steel pipe shall be sleeved with nut ferrule, and the joint shall be inserted in the steel management, and then the nut can be tightened. The front joint of the ferrule shall be tightly fitted with the body cone and the outer side of the end, and the seamless steel pipe can only be bited in after the inner edge is even, so as to form an effective seal.

Features of ferrule joint:

First, tighten the nut with the ferrule type connector, and tighten the ferrule connector to the 24 ° cone. When the ferrule is inserted into the steel pipe, it can form a seal, and its installation is very convenient.

Second, the spanner can be used for manual installation, and the elastic ferrule seal ring technology has the ability of anti leakage.

Second, ordinary welded joints are not skilled in the installation process, resulting in material oxide skin pollution of the pipeline, but also affect the cleanliness of the pipeline.

Third, the ferrule type joint is used in high and low pressure pipeline system. Because the ferrule type joint uses precision seamless steel pipe, it will cause leakage and air leakage. We suggest that technicians should read the installation instructions of our products in detail when using the main flared joint and ferrule joint, and install according to the installation sequence we marked, which is very important.

Fourth, it is necessary to check whether the front end of the ferrule of the steel pipe is squeezed or clamped, or the front edge of the ferrule has been wrapped, etc. If it is formed, the ferrule joint cannot move forward and backward on the steel pipe.

The wall thickness of the steel pipe inserted by the ferrule type joint is required to be φ 8 - φ 15 > 1mm, φ 16 - φ 1 > 1.5m, φ 20 - φ 35 > 2mm, φ 38 - φ 42 > 2.5mm. The steel pipe shall be internally plugged.